TB (Travelling Beam Machine)
Designed for simultaneous working experience, user can be very productive because of the ease of use this machine provides.
CUTTING FORCE tons 200 160 130 100 80
MATERIAL WIDTH mm. 2500 2000 1600 1200 900
MATERIAL DEPTH mm. 1500 1200 900 600
TB (Travelling Beam Machine)
Designed for simultaneous working experience, user can be very productive because of the ease of use this machine provides.
Cutting force : 250. 200 160 130 100 60
Material width: 2200 2000 1800 1600 1200
Material Depth: 1500 1200 1000 80
Full Cut
TB is designed especially for full cut works. Up to 200 Tons pressure.
Simultaneous working experience
Perform next cycle by simply walking out of the sensors. Operator can continuously working with the machine without touching any button!
Easy setup
Putting up new die or new material are now easier than ever. With auto-die setting function, operator does not have to adjust any mechanical parts.
Safety fully equipped
2 sets of CAT4 light curtains and safety modules. Emergency stop buttons. All rounded 2 meter high covers.
This travelling beam cutting machine is intended for cutting plate and roll material. The machine is designed in a very stable welded steel construction. As a result, the machine has good synchronization properties. The 4-pillars are connected to tie rods, which are brought downwards by the hydraulic cylinder. On the right and left seated tie rods which are connected via toggle with synchronizing shafts, the machine receive a better parallelism. The machine has an automatic column lubrication. The control system is user-friendly attached to the machine. Depending on the version machine is equipped with low-point-stoppers and also kiss-cut is possible.
This travelling beam cutting machine is intended for cutting plate and roll material. The machine is designed in a very stable welded steel construction. As a result, the machine has good synchronization properties. The 4-pillars are connected to tie rods, which are brought downwards by the hydraulic cylinder. On the right and left seated tie rods which are connected via toggle with synchronizing shafts, the machine receive a better parallelism. The machine has an automatic column lubrication. The control system is user-friendly attached to the machine. Depending on the version machine is equipped with low-point-stoppers and also kiss-cut is possible.
Customization & Option
Material & Tooling
